Odhav, Ahmedabad, Gujarat · Manufacturer & exporter of EOT cranes since 2013 +91 98246 98602info@electrocrane.com

Guide · 6 min read

Parts of an Overhead Crane and Their Functions

Bridge, end carriages, hoist, hook block, runway and controls — what each part does.

Overhead Crane Parts and Functions

Knowing the main parts of an overhead crane helps you write a clear specification, talk to your crane supplier and plan maintenance. Here are the key components of a typical EOT crane and what each one does.

Structure

Bridge girderThe main beam(s) spanning the bay. One girder on a single girder crane, two on a double girder crane. Rolled I-beam with capping channel, or fabricated box section.
End carriagesFitted at each end of the bridge, carrying the wheels that run on the runway rails. On our cranes they use a twin drive for straight, even long travel.
Runway beams & railsGantry girders and rails along the building that the crane travels on.
End stops & buffersStop the crane and trolley safely at the end of travel.

Lifting machinery

Hoist / crabThe lifting unit. An electric wire rope hoist on a single girder crane, or a crab on rails on a double girder crane.
Rope drumWinds the wire rope. On our hoists it is fabricated from seamless pipe with grooves for proper rope seating.
Wire rope & rope guideWire rope to IS 2266 carries the load; the rope guide keeps it correctly wound on the drum.
Hook blockForged hook (IS 3815, or IS 15560 on request) on a thrust bearing, with sheaves for the rope falls.
GearboxHelical alloy-steel gears, hardened and tempered, reduce motor speed to hoisting speed.
BrakesACEM / DCEM disc brakes (or shoe brakes) hold the load and stop each motion; fail-safe on power loss.

Motions and drives

An EOT crane has three motions: hoisting (up/down), cross travel (CT — the trolley across the bridge) and long travel (LT — the bridge along the building). Each is driven by crane-duty squirrel cage induction geared motors; on our cranes these are IP55, S4 duty, 40% CDF.

Electricals and controls

Down shop lead (DSL)Feeds power to the crane along the runway: shrouded bus bars, trailing cable, MS angle iron or bare copper conductors.
CT power supplyC-rail festoon cable system or cable drag chain to the hoist.
Control panelContactors, overloads and protection for each motion; VFDs if specified.
Pendant / radio remoteOperator control from the floor; radio remote or cabin control as options.
Limit switchesPrevent over-hoisting and over-lowering and limit travel at the ends.
Maintenance tip: the parts that wear fastest — wire rope, brake linings, wheels and limit switches — are also the ones that protect people. Inspect them on a regular schedule. Our EOT crane service team can set one up for you.

Need parts or a crane kit for in-house fabrication? See crane components & kits.

FAQs

What are the three motions of an EOT crane?

Hoisting (up and down), cross travel of the trolley across the bridge, and long travel of the bridge along the building.

What is a DSL in an overhead crane?

The down shop lead — the conductor system that supplies power to the crane along the runway, such as shrouded bus bars or bare conductors.

Talk to an engineer

Tell us the load, span and lift.
We will engineer the crane.

Share your capacity, span, height of lift and duty. Electro Crane will reply with a technical offer and quotation.

+91 98246 98602
Call
Inquiry Now